Pages

Showing posts with label starburst. Show all posts
Showing posts with label starburst. Show all posts

Sunday, 26 February 2017

Better late than never!


It's the second week of our Sunburst/Starburst Challenge at the Christmas Card Throwdown.


I mentioned last week that I wanted to try a different technique that generated less waste. I got the idea from this youtube video. I started these on Wednesday, but a continuing horrible cold and Bethany being under the weather mean I've only just got finished!

This approach relies more on measuring and planning. I used a base of 16.9cm by 11.8cm, to go on a 5x7 card base, then a template of 14.9cm by 9.8cm for the burst. I cut four papers to size for the burst, as well as a copier paper template. On the template, pick a centre point, then draw 12 lines out from this, to create your burst.

I did do a dry run of this with just copier paper, and found that you need to have the same number of lines ending on each side for the spacing to work - you can see where I've altered the pattern below.


Put the papers in the order you want to use them, then put the template on top and clip together.


And cut along your lines. I used scissors, I'm not good with a knife freehand, and the clips make a ruler difficult to use.


When you have your 12 shapes, lay them out and remove the clips. Discard the template. Then go round the circle, leaving the first section as it is, then on the next moving one piece from the top to the bottom of the pile, two pieces on the  next, and three on the next. Repeat all round the circle. This means that you can easily make your four bursts without ending up with the same pattern next to itself.


I cut my base pieces from 4 different red papers. On the first, I took the top piece from each pile and glued it onto place, using a glue pen. I found it easiest to start with the corner pieces, then fit the others in-between. For this style, I left a gap between the pieces, rather than butting them up against each other like last week.

Then repeat with the next base and the next layer from the piles.


So here are my four burst backgrounds, with no waste!

For toppers, I went super simple! I had a set of pictures that I'd cut up from a design paper last year. I chose four, and mounted them on the off cuts from cutting the bases. I edged each with aged mahogany distress ink, and with Crafters Companion clear overlay sparkle pen. This is a new purchase, I'm very pleased with it!

The backgrounds went onto the card bases using a tape pen, and I used foam pads for the toppers.








A simple way to make four variations of a card, quickly and easily.





To join in with the challenge, visit the Christmas Card Throwdown, you have until this Friday, 3rd March, midnight GMT.



Saturday, 18 February 2017

Starburst


It's our first technique challenge of the year at the Christmas Card Throwdown.


I had to go and look this one up and check with my design team colleagues - not one I'd heard of before. But having watched a few youtube videos (this one in particular inspired this card) and had a play, I'm completely won over. It looks great, and is a good way to use up design papers.

So, I started by going through my stash to find some coordinating designs. It's a little disconcerting, as there are papers that I have no recollection of buying! I came up with a selection of grey-green papers. I also ran some cream pearlescent card through a few embossing folders, to add into the mix.


Once I had my selection, I cut strips roughly 13cm by 5cm, then cut them diagonally to make triangles.


I went for the holly embossed pattern for this card.

I cut a piece of scrap paper to size (16.4cm by 11.3cm, to fit on a 5x7 card base) and covered it with thin adhesive backing. You can use glue, but I had this and I thought it might be neater and less messy.

Then it's a case of positioning the triangles around a central point. It goes really quickly.


Even at this stage I think it looks good! I trimmed off the excess, and cut a piece from it to fill the gap.


There is a lot of waste with this, although I've kept all the offcuts. For next week I'm hoping to try a different approach that avoids this - if it works!

So that's the starburst done. It's such a pleasing effect, and could be the base for so many other techniques and styles.

For now, as our whole household has been struck down with a horrible lurgy cold, simple is the name of the game.

I cut a bauble die from the cream pearl card, and a backing piece from one of the patterned papers.


This will go over the centre of my burst, to hide the slight unevenness.

For a sentiment, I used a Clarity stamp. In the style I wanted my usual "Merry Christmas" is part of a larger stamp so needs masking, so I went with the stand alone "Christmas Greetings". I used watering can archival ink on the pearl card, and cut it into a banner.


I gave it a bit of a wave.

I cut some turquoise card as a mount, and attached with tape pen. For the bauble I used a zig glue pen to attached the die cut to the backing, them foam pads to lift it from the card. The sentiment then tucked under this, using glue dots to hold it in shape.



I so enjoyed making this, it's great to add such a lovely new technique to my repertoire.





If you would like to join in with the challenge, head over to the Christmas Card Throwdown. You have until Friday 3rd March to try this stunning technique.